Showing 1–16 of 3 results
Sorry already exist in cart.
10% off
Gsm Starter
11,210 12,500
In GSM based technology, the GSM Pump Controllers (Mobile
Pump Starter) are specifically design to operate remote located submersible
pumps and motors for benefit of farmers, agriculture people and industries
where wireless pump and motor control required. Our GSM based mobile pump
controller is manufactured with advanced micro controller technology and
quality process. Multiple variant also available like for controlling and
resetting inverter with trip acknowledgement. Latch based Start/Stop relay
operation variant also available.
41% off
Gsm Modem Sim800C
1,062 1,800
GSM SIM800C Modem with Antenna Module's baud rate is
configurable from 9600-115200 through AT command. The GSM GPRS Modem is having
internal TCP/IP stack to enable you to connect with internet via GPRS. It is
suitable for SMS, Voice as well as DATA transfer application in M2M interface.
The on-board Regulated Power supply allows you to connect wide range
unregulated power supply. The Modem using this modem, you can make audio calls,
SMS, Read SMS, attend the incoming calls etc. through simple AT commands. Is
built with Quad-Band GSM/GPRS engine-SIM800C from SIMCOM, works on frequencies
850/ 900/ 1800/ 1900 MHz. The Modem is populated with MAX232 Interface
connector so as to directly connect with computer or other RS232 Compatible
devices. MAX3232 is used for the RS232 Level conversion. The modem will work
with 10-15V DC, which can be fed either through onboard 2 Pin connector. The
modem is powered by High Current Low Dropout Linear Voltage regulator so as to
withstand high surge current requirement (may rise up to 2A).
60% off
GSM MODEM PCB SIM800/900
180 450
This GSM modem has a
SIM800A/900 chip and RS232 interface while enables easy connection with the
computer or laptop using the USB to Serial connector or to the microcontroller
using the RS232 to TTL converter. Once you connect the SIM800/900 modem using
the USB to RS232 connector, you need to find the correct COM port from the
Device Manger of the USB to Serial Adapter. Then you can open Putty or any
other terminal software and open an connection to that COM port at 9600 baud
rate, which is the default baud rate of this modem. Once a serial connection is
open through the computer or your microcontroller you can start sending the AT
commands. When you send AT commands for example: "AT\r" you should receive back
a reply from the SIM800 modem saying "OK"or other response depending on the
command send. SIM800/900 is a complete Quad-band GSM/GPRS solution in a LGA
type which can be embedded in the customer applications. SIM800H support Quad-band 50/900/1800/1900MHz, it can transmit Voice, SMS and data information
with low power consumption. With size of Sim800/900, it can fit into slim and
compact demands of customer design. Featuring and Embedded AT, it allows total
cost savings and fast time-to-market for customer applications.
